考虑膨胀剂PEC柱的黏结滑移性能
作者:
作者单位:

1.内蒙古科技大学 土木工程学院,内蒙古 包头 014010;2.内蒙古自治区高校智能建造与 运维工程研究中心,内蒙古 包头 014010;3.中恒丰建筑集团有限公司, 北京 102627;4.诺丁汉大学 土木工程系,英国 诺丁汉 NG72RD

作者简介:

曹芙波(1976—),男,湖南衡阳人,内蒙古科技大学教授,硕士生导师,博士. E-mail: caofubo@139.com

通讯作者:

王晨霞(1977—),女,内蒙古集宁人,内蒙古科技大学副教授,硕士生导师,博士. E-mail: 14755826@qq.com

中图分类号:

TU398

基金项目:

国家自然科学基金资助项目(51868061);内蒙古自治区自然科学基金资助项目(2020MS05071, 2022LHMS05011)


Bond Slip Performance of PEC Column Considering Expansion Agent
Author:
Affiliation:

1.School of Civil Engineering, Inner Mongolia University of Science and Technology, Baotou 014010, China;2.Intelligent Construction and Operation Engineering Research Center at Universities of Inner Mongolia Autonomous Region, Baotou 014010 , China;3.Zhonghengfeng Construction Group Co., Ltd., Beijing 102627, China;4.Department of Civil Engineering, University of Nottingham, Nottingham NG72RD, UK

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献 [16]
  • |
  • 相似文献 [20]
  • | | |
  • 文章评论
    摘要:

    为探究部分包裹混凝土(PEC)柱在膨胀剂作用下的黏结滑移性能,设计了6组试件进行短柱推出试验,探究了混凝土强度、黏结长度和膨胀剂掺量对H形钢与混凝土之间黏结性能的影响,分析了黏结应力的组成,建立了反映黏结滑移性能的数值模型.结果表明:H形钢和混凝土之间的黏结性能与混凝土强度、黏结长度以及膨胀剂掺量呈正相关;H形钢与混凝土之间黏结应力的81.6%由摩擦应力提供,考虑黏结长度的摩擦应力与化学胶结力的比值稳定在42%~47%;依据试验建立的折线式黏结滑移本构模型可以较好地反映黏结应力与位移的关系,采用非线性弹簧建立的有限元模型与试验结果吻合较好.

    Abstract:

    Work on the bond-slip performance of partially encased concrete (PEC) under the action of expansion agent was carried out. Six groups of specimens were designed to carry out short column push-out test. The effects of concrete strength, bond length and expansion agent content on the interface bonding performance between H-shaped steel and concrete were investigated. The composition of bond stress was analyzed, and the numerical model reflecting the bond-slip performance was established. The results show that the improvement of bonding performance is positively correlated with concrete strength, bonding length and expansion agent content. 81.6% of the bond stress between H-shaped steel and concrete is provided by friction stress, and the ratio of friction stress to chemical bond force considering bond length is stable at 42%-47%. The broken-line bond-slip constitutive model established according to the test can better reflect the relationship between bond stress and displacement. The finite element model established by nonlinear spring is well fitted with the test results.

    表 3 试件参数Table 3 Parameters of specimens
    表 2 钢材的性能Table 2 Properties of steel materials
    表 1 混凝土的配合比和性能Table 1 Mix proportions and properties of concretes
    表 5 黏结分布计算结果Table 5 Calculation results of bond distribution
    图1 PEC推出试件Fig.1 PEC push-out specimen
    图2 加载示意图及装置Fig.2 Loading diagram and device
    图3 试件的荷载-滑移曲线Fig.3 Curves of load-displacement of specimens
    图4 试件的平均黏结-滑移曲线Fig.4 Average bond-slip curves of specimens
    图5 试件试验曲线与拟合曲线的对比Fig.5 Comparison of test curves and fitting curves of specimens
    图6 试件PEC-40-10-400的Mises应力云图Fig.6 Mises stress nephogram of specimen PEC-40-10-400
    图7 试件黏结-滑移曲线模拟结果与试验结果的对比Fig.7 Comparison of simulation results and test data of bond-slip curves of specimens
    表 4 特征黏结应力Table 4 Characteristic of bond stress
    参考文献
    [1] 白国良. 型钢钢筋混凝土原理与设计[M]. 上海:上海科学技术出版社, 2000.
    [2] 应武挡. 型钢高强混凝土界面黏结滑移试验研究与理论分析[D]. 桂林:广西大学, 2014.
    [3] WANG Y Q, KANG L. Seismic performance of Q690 high strength steel welded h-section columns[J]. Procedia Engineering, 2017, 210:286-296.
    [4] CHEN Y Y, WANG T, YANG J, et al. Test and numerical simulation of partially encased composite columns subject to axial and cyclic horizontal loads[J]. Internatioal Journal of Steel Structures, 2010, 10(4):385-393.
    [5] WANG H, LI J, SONG Y C. Numerical study and design recommendations of eccentrically loaded partially encased composite columns[J]. International Journal of Steel Structures, 2019, 19(3):991-1009.
    [6] NING K Y, YANG L, BAN H Y. Seismic performance of welded stainless steel h-section columns under cyclic horizontal loading[J]. Journal of Structural Engineering, 2021, 147(4):04021016.
    [7] CAO X L, ZHONG R, XU Y, et al. Local-overall interactive buckling behaviour of 800 MPa high-strength steel welded h-section members under axial compression[J]. Thin-Walled Structures, 2021, 164:107793.
    [8] 赵根田, 张宇鸣, 曹芙波, 等. 焊接H形钢部分包裹高强混凝土柱抗震性能试验研究[J]. 建筑结构学报, 2019, 40(4):116-122.
    [9] 赵根田, 王聊杨, 冯超. 薄柔H形钢部分包裹混凝土梁柱组合体抗震性能研究[J]. 建筑结构学报, 2013, 34(增刊1):96-101.
    [10] 郑华海, 陈宗平, 苏益声. 型钢再生混凝土界面黏结应力组成及其强度[J]. 同济大学学报(自然科学版), 2016, 44(10):1504-1512.
    [11] 伍凯, 徐佳楠, 陈峰, 等. 型钢-钢纤维混凝土黏结性能及界面损伤分析[J]. 建筑材料学报, 2020, 23(3):572-580.
    [12] 柳战强, 郭子雄, 叶勇. PSWR-PM加固层与混凝土界面黏结性能试验研究[J]. 建筑材料学报, 2022, 25(8):798-805.
    [13] 秦艳. 考虑粘结滑移的型钢混凝土非线性有限元分析[D]. 西安:西安理工大学, 2007.
    [14] IZZUDDIN B A, KARAYANNIS C G, ELNASLMI A S. Advanced nonlinear formulation for reinforced concrete beam-columns[J]. Journal of Structural Engineering, 1994, 120(10):2913-2934.
    [15] CHICOINE T, TREMBLAY R, MASSICOTTE B, et al. Behavior and strength of partially encased composite columns with built-up shapes[J]. Journal of Structural Engineering, 2002, 128(3):279-288.
    [16] 应武挡, 陈宗平. 型钢高强混凝土界面粘结传力机理及影响因素分析[J]. 土木工程学报, 2016, 49(9):53-63, 71.
    引证文献
    网友评论
    网友评论
    分享到微博
    发 布
引用本文

曹芙波,谢庆,李涛,汪方莹,王晨霞.考虑膨胀剂PEC柱的黏结滑移性能[J].建筑材料学报,2022,25(11):1177-1184

复制
分享
文章指标
  • 点击次数:134
  • 下载次数: 423
  • HTML阅读次数: 13
  • 引用次数: 0
历史
  • 收稿日期:2022-05-03
  • 最后修改日期:2022-07-22
  • 在线发布日期: 2022-11-30
文章二维码